Green Light Power Switching | Crestron Commercial Lighting Design Guide |
GLPS-SW-FT Green Light Express Feed-
ThroughPower Switching Panels w/Standard
The
The
The
As part of a complete Green Light system,
Remote emergency override mode allows the lighting system program to be overridden while each circuit is set to an override preset state. The override preset for each circuit is set using the local controls on the front of each lighting module. Remote override mode is activated by an external contact closure from a Crestron
All
Crestron Green Light Express Power Switching panels are configured to order, and factory assembled and tested prior to shipping. Each panel is engineered to provide a clean and manageable installation with abundant provisions for wire termination and conduit knockouts.
MODEL NUMBERS
Specifying and ordering a Crestron Green Light Express Power Switching panel is facilitated using the following model number system. Simply
fill in the appropriate entry in each position according to the steps that follow:
GLPS - SW - FT - 56
GLPS – Relay Type – Feed Type – Number of Ckts.
The above example is for a
Relay Type: Enter “SW” to specify standard
Note: For other relay types, refer to the Selection Guide on Page 3.
Feed Type: Enter “FT” to specify
Note: For other feed types, refer to the Selection Guide on Page 3.
Number of Circuits: Choose one of the following numeric values to specify the number of controlled circuits in the panel:
Small: 8, 16, 24
Large: 32, 40, 48, 56
Note: “Small” and “Large” refer to the default panel size per number of circuits. Consult Crestron Sales Support Services for alternate configurations.
Doc.4775A | 22 |