D-Link DES-5200 manual ∙ Cold Start ∙ Authentication Failure ∙ Link Change Event

Fast Ethernet Switching System User’s Guide

∙Cold Start

∙Authentication Failure

∙Link Change Event

Cold Start

Signifies that the DES-5200 has been powered up. Software settings are reconfigured and hardware systems are rebooted. A cold start is different from a factory reset.

Authentication Failure

Signifies that an addressee (or manager/ user) on the DES-5200 is not a valid user of the DES-5200 and may have entered an incorrect community name.

Link Change Event

Signifies that the link of a port has changed from link up to link down or vice versa.

IP Address

This field is used to enter the IP Addresses of Trap Managers.

SNMP Community String

Enter the Community String of the Trap Managers in this field.

Status

The DES-5200 will not send out traps unless the status is Valid.

Follow these steps to enter the SNMP Community String:

1.Enter the name of the SNMP Community.

2.Select the Access Right field and use the down arrow to change the setting.

3.Select Apply. Select Refresh to see the changes.

Follow these steps to configure the SNMP Trap Manager Setting:

1.Enter the IP Address of the Trap Manager.

2.Enter the name of the SNMP Community String.

3.Press Apply. Select Refresh to see the changes.

Web Management 116