D-Link DIR-455 manual Configure WEP, Next to Security Mode, select Enable WEP Security

Section 4 - Security

Configure WEP

It is recommended to enable encryption on your wireless router before your wireless network adapters. Please establish wireless connectivity before enabling encryption. Your wireless signal may degrade when enabling encryption due to the added overhead.

1.Log into the web-based configuration by opening a web browser and entering the IP address of the router (192.168.0.1). Click on Wireless Settings on the left side.

2.Next to Security Mode, select Enable WEP Security.

3.Next to Authentication, select Open or Shared Key.

4.Select either 64-bitor 128-bitencryption from the drop-down box next

to WEP Encryption.

5.Next to Key Type, select either Hex or ASCII.

Hex (recommended) - Letters A-F and numbers 0-9 are valid. ASCII - All numbers and letters are valid.

6.Next to Key 1, enter a WEP key that you create. Make sure you enter this key exactly on all your wireless devices. You may enter up to 4 different keys.

7.Click Save Settings to save your settings. If you are configuring the router with a wireless adapter, you will lose connectivity until you enable WEP on your adapter and enter the same WEP key as you did on the router.

D-Link DIR-455 User Manual 67