3.Route a straight, uncrimped Ethernet cable (8-wire, 24 AWG) through both the top nut and the waterproof seal.
NOTE: The 8-wire cable should be shielded.
4.Insert and crimp the RJ-45 connector. Refer to Appendix B for instructions on preparing the RJ-45 cable connector.
5.Connect the Ethernet cable to the Outdoor unit RJ-45 connector.
6.Replace the waterproof seal and then the top nut. Make sure that the external jack of the cable is well inside the waterproof seal to guarantee a good seal.
7.Route the cable to the location selected for the Indoor unit.
2.5Installing the Indoor Unit
Route the Indoor-to-Outdoor cable into the building so that it conveniently reaches the indoor unit while avoiding interference sources. It is recommended that the cable be a little longer then necessary. The cable is supplied open ended so it can be conveniently threaded as shown into the building.
1.Remove the wall-mounting bracket clipped to the back of the indoor unit and mount it on a wall as shown in Figure 6. Mount the indoor unit on the mounting bracket.
2.Assemble an RJ-45 connector with a protective cover on the indoor side of the Indoor-to-Outdoor cable. Refer to Appendix B for instructions on preparing the RJ-45 cable connector.
3.Connect the Indoor-to-Outdoor cable to the Radio connector, located on the top panel of the indoor unit shown in Figure 8 on page 14. The Indoor-to-Outdoor cable should be connected to the unit before the unit is connected to the mains power.
12
