TABLE OF FIGURES |
|
Figure 1: | 2 |
Figure 2: General Installation Scheme - Pole Mounting | 5 |
Figure 3: Holes/Grooves/Screw Holes | 10 |
Figure 4: 3” Pole Mounting Installation Using the Supplied Brackets | 11 |
Figure 5: The Waterproof Seal | 11 |
Figure 6: Wall Mounting the Indoor Unit | 13 |
Figure 7: Indoor Unit Bottom Panel | 13 |
Figure 8: Indoor Unit Top Panel | 14 |
Figure 9: | |
.................................................................................................................. | 21 |
Figure 10: The Set IP Dialog Box | 22 |
Figure 11: Station Status Tab | 24 |
Figure 12: IP Parameters Tab | 25 |
Figure 13: SNMP Parameters Tab | 26 |
Figure 14: Counters Tab (BU Units) | 27 |
Figure 15: Counters Tab (RB Units) | 27 |
Figure 16: WLAN Parameters Tab (BU Units) | 29 |
Figure 17: WLAN Parameters Tab (RB Units) | 30 |
Figure 18: The Station Control Tab | 33 |
Figure 19: Security Tab | 34 |
Figure 20: Advanced Tab | 35 |
Figure 21: Trap Monitor Tab | 37 |
Figure 22: Firmware Upgrade Mode dialog box | 38 |
Figure 23: Firmware Upgrade Process | 39 |
Figure 24: Advanced TFTP Setup dialog box | 40 |
Figure 25: Multiple Configuration Mode dialog box | 41 |
Figure 26: Ethernet Connector Pin Assignments | 56 |
Figure 27: A Typical Radio System | 577 |
Figure 28: Attenuation of an RF signal | 588 |
Figure 29: Radiation Pattern of Directional Antenna | 60 |
Figure 30: Multipath Reception | 62 |
Figure 31: Fresnel Zone | 63 |
Figure 32: Fresnel Zone Clear of Obstacles | 64 |
iv