REFERENCES

5

 

5.3.3Address Stamping

It is possible to include the reader address in the message sent to the host. The reader Address Stamping parameter consists of a 4-digit number in the range 0000-1999.

For message output format, refer to par. 5.3.

5.3.4Address Delimiter

The Address Delimiter allows a character to be included to separate the reader Address stamping field from the next field in the message. Any character can be included in the hexadecimal range from 00 to FE.

For message output format, refer to par. 5.3.

5.4POWER SAVE

5.4.1Sleep State

This mode allows the P in the reader to enter a “Sleep” state for minimum power consumption. For D-series readers, this command is only valid when hardware trigger type is selected.

Before entering Sleep mode, the following are verified:

no commands coming from Host

no data being transmitted to Host

Enter Sleep Timeout ended (see par. 5.4.2)

To exit Sleep mode press the trigger.

Enabling the Sleep state implements Standby mode for CCD devices, see par. 5.4.3.

For M-series readers, sleep state is entered immediately after reading a code and is not configurable. To exit Sleep mode press the trigger.

5.4.2Enter Sleep Timeout

For readers that have the Sleep state enabled, this timeout determines when the reader will enter this state.

125

Page 135
Image 135
Datalogic Scanning 90ACC1780 manual Address Stamping, Address Delimiter, Sleep State, Enter Sleep Timeout, 125