Datalogic Scanning 90ACC1780 Configuration Methods, Reading Configuration Barcodes, Copy Command

CONFIGURATION 4

4 CONFIGURATION

4.1CONFIGURATION METHODS

4.1.1Reading Configuration Barcodes

This manual can be used for complete setup and configuration of your reader by following the setup procedures in this chapter (see par. 4.2 for an overview).

If you wish to change the default settings, this manual provides complete configuration of your reader in an easy way.

To configure your reader:

1)Open the folded page in Appendix C with the hex-numeric table and keep it open during the device configuration.

2)Read the Enter Configuration code ONCE, available at the top of each page of configuration.

3)Modify the desired parameters in one or more sections following the procedures given for each group.

4)Read the Exit and Save Configuration code ONCE, available at the top of each page of configuration.

Reference notes describing the operation of the more complex parameters are given in chapter 5.

4.1.2Using DL Sm@rtSet

DL Sm@rtSet is a Windows-based utility program providing a quick and user-friendly configuration method via the RS232 interface.

It also allows upgrading the software of the connected device (see the DL Sm@rtSet User's Manual for more details).

4.1.3Copy Command

A previously configured device (Master), can be used to send its configuration directly to other devices of the same type (Slaves). The particular procedure for each device is given in par. 5.9.

11