Connecting the Power Supply

If supplied, plug the connector from the external power supply into the receptacle located on the housing connector. Then plug the power supply into a power source.

Connecting a Magnetic Stripe Reader

If a detached Magnetic Stripe Reader (MSR) is to be used, plug the connector into the MSR receptacle located on the housing connector.

Terminal Power-Up Sequence

Turn on the power to the terminal to which the PSC scanner is con- nected. The unit will issue a series of beeps which are intentional and indicate that the terminal/keyboard power-on reset routines have been completed.

Programming for Terminal Type

If this is a first-time installation, it is NECESSARY to pro-

gram the PSC scanner for use with the connected termi-

nal.

NOTE

Proceed as follows:

1.Using the Keyboard Wedge Parameters menu given in the Keyboard Wedge Parameters Section scan:

WEDGE MODE ENABLE (CE)

This sets the PSC scanner into a Keyboard Wedge interface mode.

2.Select the terminal type by next scanning the appropriate symbol for your terminal.

Scanning Reset to Default (ZA) will cause the PSC scan-

ner to revert to Keyboard Wedge mode with a PC-AT termi-

nal type.

NOTE

06656

3

Page 11
Image 11
Datalogic Scanning DS1100 SH2347, DS2200 SH2348 Connecting the Power Supply, Connecting a Magnetic Stripe Reader, Nal type