Datalogic Scanning Industrial PDA Regulatory Statements, Laser Safety Label, Advisory Statement

Safety Information

Laser Safety Label

Laser Safety Label

CLASS 2 LASER PRODUCT 1.0mW Max Output: 645 to 660nM Complies with 21 CFR 1040.10 and1040.11 EN60825 1+A2:2001

This figure illustrates an example of a laser safety label, which is located on the scanning pod of laser-based Pegaso units. The label on your unit may appear different or have different informa- tion. Please refer to your unit for specific laser safety requirements.

The Advanced Long Range Laser is rated Class 3R per EN60825-1 and Class II per CFR 1040.

Models with the Linear Imager are rated LED Class 1 per IEC 60 825-1:2001, only.

Advisory Statement

Use of controls, adjustments, or performance of procedures other than those specified herein may result in hazardous

CAUTION visible or invisible laser light exposure.

Regulatory Statements

Federal Communication Commission

Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a resi- dential installation. This equipment generates, uses and can radiate radio fre- quency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. How- ever, there is no guarantee that interference will not occur in a particular instal- lation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following mea- sures:

•Reorient or relocate the receiving antenna.

•Increase the separation between the equipment and receiver.

Quick Reference Guide 52