Datamax E-4304e, E-4203 manual Slide the Media Guide and Media Hub Flange to the edge of the media

5. Slide the Media Guide and Media Hub Flange to the edge of the media.

6.Close the Printhead Carrier Assembly and press down until it locks into place.

7. Close the cover and press the Feed button several times to position the media and ensure proper tracking.

(If the printer does not correctly sense the top of each label, as denoted by the FAULT Light, it may be necessary to perform the Calibration Procedure, Section 4.6.)

;Note: The printer is factory set to use 4-inch media (and ribbon, if thermal transfer equipped). When using a different width of media/ribbon, please refer to Chapter 5.

E-4203/E-4204/E-4304 13