Datamax E-4204, E-4203, E-4304e Printer Setup Mode - Button Functions, To change Printer Setup

4.4Printer Setup Mode - Button Functions

In ‘Printer Setup’ mode, the buttons control the setting of the printer’s operational items such as media settings, communications, and options as detailed below.

;Notes: It is recommended that the Printer Setup Mode not be entered while in Peel Mode or with the optional Present Sensor enabled. Depending on label size this can cause unpredictable results.

Printer and cutter faults are disabled during , but can still occur while printing “test” labels.

If at any time you wish to discard your changes and revert back to the previous values, simply turn off power to the printer.

If you wish to restore Factory Defaults see Section 5.7.

To change Printer Setup:

F1 (Press and hold during power-up until the Paused Light turns off)

Printer Setup Mode

F1

F2

F2

F3

Prints the ‘Printer Setup Menu List’, see section 4.4.1

(PressReleaseand)Feeds one label for “test”

(Press and hold to advance to the desired menu ) item by counting the number of Fault Light flashes

Prints the ‘Test Label’ for “test”

F1 + F3	Saves the current values
	and resumes	Normal Mode

Printer Setup Procedure (Current Item and Value is printed)

	F1	Increments item’s value
	F2	(PressReleaseand)Selects the next menu item
	F2		Press and		)	“Direct Select” menu item (e.g., 7 Fault Light flashes = Baud Rate,
		(		Hold			menu item #7; see Section 4.4.3)
	F3	Decrements item’s value
	F1	+ F3		Accepts the current
				values for “test”
E-4203/E-4204/E-4304						21