Datamax E-4304e, E-4203, E-4204 manual Calibration Mode Button Functions, To perform Calibration

4.6Calibration Mode – Button Functions

In ‘Calibration’ mode, the buttons allow the printer to adjust to the media being used. Calibration can be performed either automatically or manually, as detailed below.

;Notes: Before calibrating, ensure that the Printhead Carrier Assembly is latched down, that the cover is closed, and that the media sensor has been set for the appropriate media type, see Section 4.4.2.

Printer and cutter faults are disabled during and

, but can still occur while printing “test” labels.

If at any time you wish to discard your changes and revert back to the previous calibration simply turn off power to the printer. Also, Factory Defaults can be restored, see Section 5.7

To perform Calibration:

F3

(Press and hold during power-up until the Paused Light turns off)

Calibration Mode

F1
Auto Media Calibration (See Section 4.6.1)
F2	(PressReleaseand) Feeds one label for “test”
F2	Press and hold until the
	( Paused Light turns on )
F3	Prints the ‘Test Label’ for “test”
F1	+ F3	Saves the current values
		and resumes Normal Mode
Media Sensor Calibration (See Section 4.6.2)
		(The Fault Indicator flashes during analysis)
	F1	Analyze media
	F2 Analyze media backing material or reflective mark
	F3	Analyze no media condition
	F1	Accepts the current
		+ F3 analysis for “test”
34		E-4203/E-4204/E-4304