3.The PAUSED Light will flash during the download.

4.Following a successful download, the PAUSED Light will illuminate then the printer will perform a ‘cold reset.’ The previous printer setup will not be affected unless substantial firmware data structure changes have occurred. Print a Database Configuration Label to verify your new firmware version.

¾Following an unsuccessful download, the FAULT Light will illuminate then the printer will perform a ‘warm reset’ (both the POWER and PAUSED Light will be on during power-up initialization). The original firmware will remain operational. If the printer fails to reset, toggle the power ‘Off’ and ‘On.’

Try re-sending the file to the printer. If the failure continues, check the following possible causes:

An invalid or corrupted file is being downloaded - Ensure the file being downloaded is correct and applicable for your printer model.

Possible communications error - Check the cable connection between the host and printer and ensure that a quality, shielded cable is used.

Possible Flash memory problem - Call for service.

If the printer fails to boot-up after an unsuccessful download, turn ‘Off’ the power. Simultaneously press and hold the F1 and F3 buttons while powering ‘On’ the printer. Now, try downloading the file to the printer.

48

E-4203/E-4204/E-4304

Page 58
Image 58
Datamax E-4204, E-4203, E-4304e manual Paused Light will flash during the download