FRI AUGUST 024, 2001 19:29 236 | CONFIGURATION |
|
|
|
| |
VER: E4204 - 04.06 | 08/24/01 | DIRECT THERMAL |
|
|
|
|
BOOT |
| SERIAL PORT SELECTED |
|
| ||
CODE |
| 19.2; 8BITS |
|
|
|
|
FONT |
| EDGE |
|
|
|
|
CPLD |
| CONT FORM LENGTH__ |
| 0 |
| |
INTERNAL FLASH MODULE PRESENT | PRESENT ADJUST____ |
| 127 |
| ||
SYSTEM RAM CHECKS____ GOOD | SOP ADJUST________ |
| 127 |
| ||
SYSTEM RAM SIZE___ | 2015 KBYTES | TOF LOW___________ |
| 0 | 0 | |
SYSTEM RAM AVAIL__ | 1244 KBYTES | TOF DELTA_________ |
| 10 | 10 | |
REG POWER SUPPLY__ | YES | TOF GAIN__________ |
| 12 | 10 | |
|
| OOS MAXVOLT_______ |
| 3 | 3 | |
|
| LABEL ALIGNMENT___ |
| NO |
| |
|
| ALIGN LENGTH______ |
| 100 |
| |
|
| STOP LOCATION_____ | HOST |
| ||
INPUT VALUES |
| COUNTER INFORMATION |
|
| ||
PAPER_____________ | 255 | ABSOLUTE VALUES |
| |||
DARKNESS__________ | 131 | LENGTH____ | 773 | INCHES | ||
TRAN______________ | 255 | TIME______ |
| 20 | HOURS | |
REFL______________ | 149 | RESETTABLE VALUES | ||||
RIBN______________ | 87 | LENGTH____ | 576 | INCHES | ||
TEMP______________ | 48 | TIME______ |
| 10 | HOURS | |
VOLT______________ | 223 | MEMORY CONFIGURATION |
|
| ||
|
|
|
| |||
|
| INTERNAL MODULE______ | 15 | |||
|
| SCALABLE FONTS_______ | 32 | |||
|
| LABEL SIZE | 0416:02157 IN | |||
The second label printed is the Dot Check Label. This label is used to test the condition of the printhead, as shown below:
Good Dot Check Label:
Even pattern consistency indicates that the printhead is operating normally.
Faulty Dot Check Label:
Streaks in the patterns indicate a dirty or faulty printhead (see Chapter 5).
38 |
|
