INSTALLATION
GAS HOOK-UP
LP TANK RESTRAINT FOR BUILT-IN INSTALLATION
If the grill is to be installed in a
The gas connector must comply with the Standard for Connectors for Outdoor Gas Appliances & Manufactures Homes, ANSI Z21.75/ CSA 6.27. The connection must be no longer than 6’ (1820mm) in length and be suitable for outdoor installation.
If you intend to operate your
The following steps will illustrate how to properly locate and install the LP tank restraint within the
NOTE:
The grill comes with the LP Regulator/Hose assembly installed at the factory. The assembly, along with the entire grill system, is leak tested.
Do not remove the Regulator/Hose assembly from the grill during installation.
The maximum distance from the center of the manifold cut out to the center of the tank restraint is 18 inches.
Center of manifold cut out projected to floor of the island.
Center of Tank Restraint must be placed within this area to avoid causing stress on the LP regulator hose connection.
The connection must be visible to the user (through a door opening or similar).
18” max.
FIG. 10
Note:
Gas piping and connectors must be clamped within the the enclosure to avoid contact with moving parts and hot sur- faces. Where the gas piping passes through an opening in the enclosure, the piping must be protected for a distance of at least 2” (50 mm) either side of the opening.
14
