DCS RGSC-305SS manual Igniters, Control Knobs - Cooktop And Oven, Care And Maintenance, Burners

Locating Pin Hole Inside

Venturi

Electrode

Locating Pin

Burner

Base

Locating Notch

Simmer Ring

Hex Nut

Main

Burner Port Ring

Brass Ring Locating Pin

Cap

CARE AND MAINTENANCE

BURNERS

For proper lighting and performance keep the burners clean. It is necessary to clean the burners if they do not light even though the igniter clicks, if there has been a severe boil over, or when the flame does not burn blue.

Be certain all burner knobs are in the OFF position before attempting to clean the burners.The burners have been designed for ease in cleaning. When the grates and burners are cool, remove the grate. The Burner Cap and the Brass Port Ring can easily be lifted off. Wash these parts in hot soapy water, rinse and dry thoroughly. The Burner Caps are porcelain enamel, follow the directions on the previous page that were given for the burner

grates. A bristle brush can be used to clean out the toothed burner

ports, if necessary. Disassembly of the Simmer Ring is not

recommended, however, it may become necessary to do so if the ports remain clogged after normal

cleaning. If it is necessary to disassemble the Simmer Ring from

the Base, remove the Hex Nut at

the top of the Simmer Ring. Clean the Simmer Ring with hot soapy

water using a soft wire or plastic bristle brush then dry thoroughly.

Re-assemble the parts using the Hex Nut.

After cleaning, it is important to make sure the Locating Pin on the

bottom side of the Simmer Ring is properly aligned with the corresponding hole in the Base

and that the Locating Pin (see insert) in the bottom side of the Brass Port Ring is properly aligned

with the Locating Notch on the top side of the Simmer Ring. Incorrect alignment will produce a potentially dangerous flame and poor burner performance. See the illustration.

IGNITERS

Wipe with a water-dampened cotton swab. Be careful not to damage the igniter. (See illustration)

CONTROL KNOBS – COOKTOP AND OVEN

These are plastic and can be cleaned in hot, soapy water. To remove the knobs from the control panel, grasp the knob and pull straight forward. Wash, do not soak. Rinse and dry thoroughly. It is important to replace these knobs on the correct gas valve on the control panel.

IGNITER (keep clean)

25