Memory Module(s) | 33
Replacing the Memory Module(s)Procedure
1Align the notch on the memory module with the tab on the
memory-module connector.
2Slide the memory module firmly into the connector at a 45-degree angle, and press
the memory module down until it clicks into place. If you do not hear the click,
remove the memory module and reinstall it.
NOTE: If the memory module is not installed properly, the computer may
not boot.
3Insert the tabs on the memory-module shield into the slots on the
system-board shield and then slide the memory-module shield toward the bottom
of the computer. Ensure that the screw hole on the memory-module shield aligns
with the screw hole on the system-board shield.
4Replace the screw that secures the memory-module shield to the
system-board shield.
Postrequisites
1Replace the back cover. See "Replacing the Back Cover" on page 20.
2Replace the stand. See "Replacing the Stand" on page 18.
3Replace the stand cover. See "Replacing the Stand Cover" on page 16.
4Follow the instructions in "After Working Inside Your Computer" on page 13.
1tab 2notch
1
2
book.book Page 33 Monday, October 8, 2012 4:27 PM