Unpacking the Cabinet | Dell 2700W specs

Unpacking the Cabinet

CAUTION: Unpacking the cabinet in a low-temperature environment may cause condensation to occur in and on the cabinet. Do not install the cabinet until the inside and outside of the cabinet are absolutely dry (hazard of electric shock).

CAUTION: The cabinet is heavy (see page 63). Use caution to unpack and move the cabinet.

Use care when moving and opening the carton. Leave the components packaged until ready to install.

To unpack the system:

1Open the outer carton and remove the accessories packaged with the cabinet (see Figure 2).

Figure 2. Unpacking the Cabinet

Installation 13

Image 13

Dell 2700W manual Unpacking the Cabinet

Contents

Users Guide July 2013 S 164201788 Table of Contents Dell UPS Management Software RS-232 and USB Communication Ports UPS Status Menu Event Log Menu Testing Batteries Dell Online Rack UPS Introduction Introduction What are You Looking For? Find It Here Finding Information UPS Output Power Safety Warnings Safety Warnings Do not add weight to slide/rail mounted equipment Inspecting the Equipment Installation Unpacking the Cabinet Unpacking the Cabinet Lifting the Cabinet 120V Rear Panel Identifying the UPS Rear Panels 230V Rear Panel Identifying the UPS Front Panel Opening the Metal Battery Cover Rackmount Setup If installing additional UPSs, repeat for each cabinet Positioning the Rails Attaching the Rails to the Rack Installing and Securing the Cabinet Installing the Battery Tray Install the UPS front cover see Figure Removing the Battery Connector Cover Installing the EBM Installing the Strain Relief Bracket EBM Installation Installing the UPS Repo Connections Wire Function Installing Remote Emergency Power-off Repo Connector Power Cord Ratings Minimum Upstream Circuit Breaker Rating UPS Output PowerUPS Initial Startup Installation UPS Startup and Shutdown OperationStarting the UPS UPS Shutdown Starting the UPS on Battery Control Button Functions Control Button Sequence Control Panel Functions Display Functions Changing the LanguageStartup Screen UPS Status Screen Locked Bypass Mode Battery ModeBad Battery Detected or Battery Disconnected UPS General Alarms Active Normal Mode Status Summary Screens Description Battery Test StatusHigh Efficiency Mode Converter Mode Event Log Battery Status Screens Description Measurements Control Screens Description Control Screens Settings Description Available Settings Default Setting SettingsIdentification Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Transferring the UPS Between Modes Transferring from Normal to Bypass Mode Transferring from Bypass to Normal Mode Setting Power Strategy Behavior on Overload Retrieving the Event Log Controlling Load Segments Through the Display Configuring Load Segments Configuring Automatic Start Delay Configuring Automatic on Battery Shutdown Configuring the UPS for an EBM Configuring Battery Settings Running Automatic Battery Tests Configuring Automatic RestartConfiguring Automatic Battery Tests RS-232 and USB Communication Ports Additional UPS Features GND RS-232 Communication Port Pin Assignment Dell Network Management Card Dell Network Management Card Optional Dell UPS Management Software UPS and Battery Care UPS MaintenanceTransporting the UPS Remove the UPS front cover see Figure Disconnect the internal battery connectors see Figure Storing the UPS and Batteries When to Replace Batteries Updating the UPS Firmware Testing Batteries Specifications Rated at nominal inputs Regulation Normal mode Power LevelsRegulation Battery mode Environmental and Safety Battery Runtimes Battery ConfigurationVoltage Fuses Accessing Alarms and Conditions TroubleshootingUPS Status Menu Event Log Menu Typical Alarms and Conditions Action Troubleshooting Troubleshooting Silencing the Alarm