Installing the Battery Tray | Dell 2700W specification

9Install the UPS battery tray (see Figure 13).

NOTE: A small amount of arcing may occur when connecting the batteries. This is normal and does not damage the unit or present any safety concern.

10Remove the right battery connector from the door and connect the internal battery connector.

11Close the metal battery cover.

Adjust the battery connector so that the door closes properly. Push the door slightly to the right and then to left.

12Tighten the thumbscrew.

Torque the screw to 0.7 Nm (6.2 lb in).

Figure 13. Installing the Battery Tray

22 Installation

Image 22

Dell 2700W manual Installing the Battery Tray

Contents

Users Guide July 2013 S 164201788 Table of Contents RS-232 and USB Communication Ports Dell UPS Management Software Testing Batteries UPS Status Menu Event Log Menu Introduction Dell Online Rack UPS Introduction Finding Information What are You Looking For? Find It Here Safety Warnings UPS Output Power Safety Warnings Do not add weight to slide/rail mounted equipment Installation Inspecting the Equipment Unpacking the Cabinet Unpacking the Cabinet Lifting the Cabinet Identifying the UPS Rear Panels 120V Rear Panel Identifying the UPS Front Panel 230V Rear Panel Rackmount Setup Opening the Metal Battery Cover If installing additional UPSs, repeat for each cabinet Positioning the Rails Attaching the Rails to the Rack Installing and Securing the Cabinet Installing the Battery Tray Install the UPS front cover see Figure Installing the EBM Removing the Battery Connector Cover Installing the Strain Relief Bracket Installing the UPS EBM Installation Installing Remote Emergency Power-off Repo Connections Wire Function Repo Connector Power Cord Ratings Minimum Upstream Circuit Breaker Rating UPS Output PowerUPS Initial Startup Installation UPS Startup and Shutdown OperationStarting the UPS Starting the UPS on Battery UPS Shutdown Control Panel Functions Control Button Functions Control Button Sequence Display Functions Changing the LanguageStartup Screen Screen Locked UPS Status Bad Battery Detected or Battery Disconnected Battery ModeBypass Mode UPS General Alarms Active High Efficiency Mode Status Summary Screens Description Battery Test StatusNormal Mode Converter Mode Battery Status Screens Description Event Log Measurements Control Screens Control Screens Description Settings Description Available Settings Default Setting SettingsIdentification Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Transferring from Normal to Bypass Mode Transferring the UPS Between Modes Setting Power Strategy Transferring from Bypass to Normal Mode Retrieving the Event Log Behavior on Overload Configuring Load Segments Controlling Load Segments Through the Display Configuring Automatic Start Delay Configuring Automatic on Battery Shutdown Configuring Battery Settings Configuring the UPS for an EBM Running Automatic Battery Tests Configuring Automatic RestartConfiguring Automatic Battery Tests Additional UPS Features RS-232 and USB Communication Ports RS-232 Communication Port Pin Assignment GND Dell Network Management Card Optional Dell Network Management Card Dell UPS Management Software UPS and Battery Care UPS MaintenanceTransporting the UPS Remove the UPS front cover see Figure Disconnect the internal battery connectors see Figure When to Replace Batteries Storing the UPS and Batteries Testing Batteries Updating the UPS Firmware Specifications Regulation Battery mode Power LevelsRated at nominal inputs Regulation Normal mode Environmental and Safety Voltage Battery ConfigurationBattery Runtimes Fuses Accessing Alarms and Conditions TroubleshootingUPS Status Menu Typical Alarms and Conditions Event Log Menu Action Troubleshooting Troubleshooting Silencing the Alarm