Manuals
/
Brands
/
Computer Equipment
/
Power Supply
/
Dell
/
Computer Equipment
/
Power Supply
Dell
2700W
- page 25
1
25
71
71
Download
71 pages, 989.51 Kb
25
Installation
|
2
Install the battery connector cover under the EBM cable to provide strain relief (see Figure 16).
Rotate the battery connector cover on its side and position under the EBM cable.
Figure 16. Installing the Strain Relief Bracket
Contents
Main
Notes and Warnings
S
Table of Contents
1 Introduction
2 Safety Warnings 3 Installation
4 Operation
5 Additional UPS Features
Page
Introduction
Page
Finding Information
CAUTION:
NOTE:
NOTE:
Safety Warnings
IMPORTANT SAFETY INSTRUCTIONS SAVE THESE INSTRUCTIONS
S
Page
Page
Installation
Inspecting the Equipment
Unpacking the Cabinet
Page
Installation
Identifying the UPS Rear Panels
Figure 5. 2700W, 208V Rear Panel
This section shows the rear panels of the Dell Online Rack models.
Figure 4. 2700W, 120V Rear Panel
Figure 6. 2700W, 230V Rear Panel
Identifying the UPS Front Panel
Figure 7. The Dell Online Rack UPS Front Panel
Rackmount Setup
Page
Page
Page
Page
Page
Page
Installing the EBM
Page
Installing the UPS
Installing Remote Emergency Power-off
Page
UPS Initial Startup
To start up the UPS:
The power cord current ratings are listed in Table 2.
Page
Operation
UPS Startup and Shutdown
Starting the UPS
Starting the UPS on Battery
UPS Shutdown
Control Panel Functions
S S S
Changing the Language
Display Functions
Startup Screen
Screen Locked
UPS Status
Page
Page
Event Log
Measurements
Control Screens
Table 6 describes the available control screens.
Identification
S S S S S
Settings
Page
Page
Page
Page
Transferring the UPS Between Modes
S S
Transferring from Normal to Bypass Mode
Transferring from Bypass to Normal Mode
Setting Power Strategy
Retrieving the Event Log
To retrieve the Event Log through the display:
1Press the button for one second to go to the main menu selection and scroll down to the
Event Log menu using the button.
Behavior on Overload
Configuring Load Segments
Controlling Load Segments Through the Display
Configuring Automatic Start Delay
S S S S
Configuring Automatic on Battery Shutdown
Configuring Battery Settings
Configuring the UPS for an EBM
Running Automatic Battery Tests
S
S S S
Configuring Automatic Restart
Additional UPS Features
S S S
RS-232 and USB Communication Ports
Page
Dell Network Management Card (Optional)
Dell UPS Management Software
UPS Maintenance
S S S S S
UPS and Battery Care
Transporting the UPS
Page
Page
Storing the UPS and Batteries
When to Replace Batteries
Testing Batteries
S S S
Updating the UPS Firmware
Specifications
This chapter provides the following specifications:
S S S S S S
NOTE:
Page
Troubleshooting
Accessing Alarms and Conditions
S S
UPS Status Menu
S
Typical Alarms and Conditions
Page
Page
Page
Silencing the Alarm