Positioning the Rails | Dell 2700W guide

NOTE: The instructions are the same for square-hole racks and unthreaded, round-hole racks. The rails fit both rack styles. The round-hole rack is shown in the illustrations.

3Select the proper holes in the rail for positioning the cabinet in the desired location in the rack.

The rails should be located at the bottom of the 4U space allocated for the UPS or 3U for the EBM.

4Position the end of the left and right rails labeled L and R facing inward.

Figure 10. Positioning the Rails

Installation 19

Image 19

Dell 2700W manual Positioning the Rails

Contents

Users Guide July 2013 S 164201788 Table of Contents Dell UPS Management Software RS-232 and USB Communication Ports UPS Status Menu Event Log Menu Testing Batteries Dell Online Rack UPS Introduction Introduction What are You Looking For? Find It Here Finding Information UPS Output Power Safety Warnings Safety Warnings Do not add weight to slide/rail mounted equipment Inspecting the Equipment Installation Unpacking the Cabinet Unpacking the Cabinet Lifting the Cabinet 120V Rear Panel Identifying the UPS Rear Panels 230V Rear Panel Identifying the UPS Front Panel Opening the Metal Battery Cover Rackmount Setup If installing additional UPSs, repeat for each cabinet Positioning the Rails Attaching the Rails to the Rack Installing and Securing the Cabinet Installing the Battery Tray Install the UPS front cover see Figure Removing the Battery Connector Cover Installing the EBM Installing the Strain Relief Bracket EBM Installation Installing the UPS Repo Connections Wire Function Installing Remote Emergency Power-off Repo Connector Power Cord Ratings Minimum Upstream Circuit Breaker Rating UPS Output PowerUPS Initial Startup Installation UPS Startup and Shutdown OperationStarting the UPS UPS Shutdown Starting the UPS on Battery Control Button Functions Control Button Sequence Control Panel Functions Display Functions Changing the LanguageStartup Screen UPS Status Screen Locked UPS General Alarms Active Battery ModeBypass Mode Bad Battery Detected or Battery Disconnected Converter Mode Status Summary Screens Description Battery Test StatusNormal Mode High Efficiency Mode Event Log Battery Status Screens Description Measurements Control Screens Description Control Screens Settings Description Available Settings Default Setting SettingsIdentification Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Transferring the UPS Between Modes Transferring from Normal to Bypass Mode Transferring from Bypass to Normal Mode Setting Power Strategy Behavior on Overload Retrieving the Event Log Controlling Load Segments Through the Display Configuring Load Segments Configuring Automatic Start Delay Configuring Automatic on Battery Shutdown Configuring the UPS for an EBM Configuring Battery Settings Running Automatic Battery Tests Configuring Automatic RestartConfiguring Automatic Battery Tests RS-232 and USB Communication Ports Additional UPS Features GND RS-232 Communication Port Pin Assignment Dell Network Management Card Dell Network Management Card Optional Dell UPS Management Software UPS and Battery Care UPS MaintenanceTransporting the UPS Remove the UPS front cover see Figure Disconnect the internal battery connectors see Figure Storing the UPS and Batteries When to Replace Batteries Updating the UPS Firmware Testing Batteries Specifications Environmental and Safety Power LevelsRated at nominal inputs Regulation Normal mode Regulation Battery mode Fuses Battery ConfigurationBattery Runtimes Voltage Accessing Alarms and Conditions TroubleshootingUPS Status Menu Event Log Menu Typical Alarms and Conditions Action Troubleshooting Troubleshooting Silencing the Alarm