Dell 2700W manual Control Screens Description

Control Screens

Table 6 describes the available control screens.

Table 6. Control Screens

Control Screens	Description
Go to Bypass	Transfers the UPS system to internal Bypass mode.
	When the Go to Bypass command is issued, the screen immediately shows the
	message for five seconds: Manual Bypass Command. The option then changes to
	Go to Normal.
	When the Go to Normal command is issued, the screen immediately shows the
	message Normal Mode Command Sent for five seconds. The option then changes
	to Go to Bypass.
Battery Test	Schedule Battery Test: yes Cancel Battery test: no
	Starts a manual battery test.
	See “Testing Batteries” on page 62.
Reset Error State	Reset Alarms: yes no
	Manually clears any latched alarms, such as bad battery detected or DC Bus
	OV/UV.
	If a bad battery alarm was also active, reset the battery test status to “Not
	Tested.”
Load Segments	Load segment 1: on off
	Load segment 2: on off
	These on/off commands override automatic load segment on/off controls made by
	the Automatic Start Delay and Automatic On Battery Shutdown settings. See
	“Configuring Load Segments” on page 49.
Restore Factory Settings	Restore Factory Settings: yes no
	Available only in Standby mode.
	Restoring the factory settings:
	S	Returns all user-configurable EEPROM settings to default factory settings
	S	Resets all pending on/off commands
	S	Clears the Event Log and resets all time stamps
	S	Resets the battery test status
	S	Initiates the Self Diagnostics test

40 Operation