Dell 180, 4100, 200 service manual Drive-Mounting Rails Removal

3. Remove the drive-mounting rails from the drive (see Figure 4-7).

drive-mounting rails (2)

drive-release tabs

Figure 4-7. Drive-Mounting Rails Removal

4.If the drive is a SCSI drive, record the setting of the SCSI address jumpers and SCSI bus termination jumper.

Some drives use an adapter between the SCSI cable and the drive connector. Check the back of the old drive for an adapter. If present, remove the adapter and retain it for use on the new drive.

When reinstalling the SCSI drive, set the SCSI address jumpers and the SCSI bus termination jumpers to the settings you recorded.

4-8 Dell PowerEdge 4100/180 and 4100/200 Systems Service Manual