Network Basics

Resetting the TCP/IP Configuration

Use the following procedure at the control panel to reset the TCP/IP configuration to the default settings:

Select Printer Setup > Connection Setup > Reset Connection Setup, then press the OK button.

Setting the Interface ID

Your IPv6-enabled printer has one interface with multiple addresses. The Interface ID is the part of the address after the prefix. The printer uses the Interface ID when assigning both the Link- Local address and automatic addresses that use router supplied prefix(es). It is not used in addresses supplied by DHCPv6. Link-Local addresses are used by nodes to communicate with other nodes on the same local network. There are two options to set the Interface ID:

The default is to have the Interface ID automatically computed from the MAC address associated with the interface. The ID is different for each device. This is the recommended method for setting the Interface ID.

The other option is to manually set the interface ID. The Interface ID must be 64 bits (8 bytes) in length, and must not contain special characters other than colons or valid hexadecimal digits (0 through 9, a through f, or A through F).

Note: If you change the Interface ID, you will be prompted to reset the printer before the changes take effect.

The Interface ID can only be set in the Embedded Web Server.

Using the Embedded Web Server

To set the Interface ID using the Embedded Web Server:

1.Launch your Web browser.

2.Enter your printer’s IP address in the browser’s Address field.

3.Click Properties.

4.Select the Protocols folder on the left navigation panel, then click TCP/IP.

5.Click the TCP/IP (v6) button.

6.Do one of the following:

Select User Interface ID from MAC address.

Select Use this Interface ID.

7.Click the Save Changes button at the bottom of the page.

Dell 7130cdn Professional Color Printer

37

User Guide

 

Page 37
Image 37
Dell 7130cdn manual Setting the Interface ID, Resetting the TCP/IP Configuration