7.To install a new system battery, hold the battery with the "+" facing up and slide it under the securing tabs of the connector.
8.Press the battery straight down into the connector until it snaps into place.
9.Install the cooling shroud.
10.Install the cable cover.
11.Install the sled in the enclosure.
12.Turn on the sled.
13.Enter the System Setup to confirm that the battery is operating properly.
14.Enter the correct time and date in the System Setup Time and Date fields.
15.Exit the System Setup.
16.Repeat steps 14 to 16 for each node.
17.To test the newly installed battery, remove the sled for at least an hour.
18.After an hour, reinstall the sled.
19.Enter the System Setup and if the time and date are still incorrect, see Getting Help.
Figure 26. Replacing the system battery
1. positive side of battery connector | 2. negative side of battery connector |
System board
Removing the system board
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
CAUTION: Exercise care when removing and installing the system board in the sled, to prevent any damage to the system board.
1.Turn off the nodes using the operating system commands, or the iDRAC, or the CMC.
50
