8Install the network card driver, if required.

See the documentation that came with your network card.

9Insert the network card into your device.

If a network with a broadcast SSID is detected, the wireless

network icon, , and the New Network Detected bubble appear in the navigation bar. Go to step 10.

If a network with a broadcast SSID is not detected, skip to step 11.

10Tap The Internet.

NOTE: If multiple networks are detected, tap the network to which you want to connect, tap The Internet, and tap Connect.

11 Tap the Start button→ SettingsConnections tab→ Connections.

12Tap the Wireless Ethernet icon.

13On the Wireless tab, tap New Settings.

14Enter the SSID next to Network Name, and tap The Internet.

15Tap the Authentication tab to enable or disable WEP settings, depending on your network type.

16Tap OK.

17Tap the connection icon, , that appears in the navigation bar.

18Tap the name of your VPN connection to enable it.

Ending a Connection

To disconnect:

When connected through dial-up or VPN, tap the Connection icon on your navigation bar and tap End.

When connected through a cable or cradle, detach your device from the cable or cradle.

When connected through the infrared sensor, move the device away from the computer.

When connected through a network (Ethernet) card, remove the card from your device.

Getting Connected

101

Page 101
Image 101
Dell HC02U-W, HC02U-C, HD03U, HC02U-B owner manual Ending a Connection, Getting Connected 101