Unpacking the Cabinet | Dell 5600W, K812N, 5600R OL HV-US specs

Unpacking the Cabinet

CAUTION: Unpacking the cabinet in a low-temperature environment may cause condensation to occur in and on the cabinet. Do not install the cabinet until the inside and outside of the cabinet are absolutely dry (hazard of electric shock).

CAUTION: The cabinet is heavy (see page 62). Use caution to unpack and move the cabinet.

Use care when moving and opening the carton. Leave the components packaged until ready to install.

To unpack the system:

1Open the outer carton and remove the accessories packaged with the cabinet (see Figure 2).

Figure 2. Unpacking the Cabinet

Installation 13

Image 13

Dell 5600W, K812N, 5600R OL HV-US manual Unpacking the Cabinet

Contents

Users Guide October 2009 164201888 Table of Contents UPS and Battery Care Transporting the UPS Additional UPS Features UPS Status Menu Event Log Menu Testing Batteries Dell Online Rack UPS Introduction Introduction What are You Looking For? Find It Here Finding Information Important Safety Instructions Safety Warnings Safety Warnings Safety Warnings Inspecting the Equipment Installation Unpacking the Cabinet Unpacking the Cabinet Lifting the Cabinet 208V Rear Panel UPS Rear Panels Dell Online Rack UPS Front Panel UPS Front Panel Removing the Battery Retaining Bracket Rackmount Setup Removing the Battery Trays Installing the Rails Installing the Cabinet Install the UPS battery trays see Figure Installation Snap the UPS front cover into place see Figure Installing the UPS Installing the EBM Repo Connections Installing Remote Emergency Power-off Repo Connector Hardwiring the UPS Input Circuit Breaker Diagram Backfeed Protection Devices Typical External Isolating Device Installation Terminal Position UPS Initial Startup UPS Startup and Shutdown OperationStarting the UPS UPS Shutdown Starting the UPS on Battery Control Button Functions Control Button Sequence Control Panel Functions Display Functions Changing the LanguageStartup Screen UPS Status Screen Locked Bypass Mode Battery ModeBad Battery Detected or Battery Disconnected UPS General Alarms Active Normal Mode Status Summary Screens Description Battery Test StatusStandby Mode Event Log Battery Status Screens Description Measurements Control Screens Description Control Screens Settings Description Available Settings Default Setting SettingsIdentification Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Settings Description Available Settings Default Setting Transferring from Bypass to Normal Mode Transferring from Normal to Bypass ModeTransferring the UPS Between Modes Retrieving the Event Log Behavior on Overload Controlling Load Segments Through the Display Configuring Load Segments Configuring Automatic Start Delay Configuring Automatic on Battery Shutdown Configuring the UPS for an EBM Configuring Battery Settings Running Automatic Battery Tests Configuring Automatic RestartConfiguring Automatic Battery Tests RS-232 and USB Communication Ports Additional UPS Features RS-232 Communication Port Pin Assignment Dell Network Management Card on a 5600W OL UPS Dell Network Management Card Optional Dell UPS Management Software UPS and Battery Care UPS MaintenanceTransporting the UPS Remove the UPS front cover see Figure Storing the UPS and Batteries When to Replace Batteries Updating the UPS Firmware Testing Batteries Specifications Rated at Nominal Inputs Regulation Normal Mode Power LevelsRegulation Battery Mode Electrical Output Operating Temperature Environmental and SafetyTemperature Relative Humidity Safety Conformance Battery Type Battery ConfigurationBattery Runtimes Voltage Accessing Alarms and Conditions TroubleshootingUPS Status Menu Event Log Menu Typical Alarms and Conditions Action UPS Troubleshooting Troubleshooting Silencing the Alarm