Back to Contents Page
System-Board Shield
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the
Replacing the
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by periodically touching an unpainted metal surface (such as a connector on your computer).
Removing the System-Board Shield
1.Follow the instructions in Before You Begin.
2.Remove the back cover (see Removing the Back Cover).
3.Follow the instructions from step 2 to step 5 in Removing the Front Stand.
4.Remove the four screws that secure the
5.Carefully lift the
1 | 2 | screws (4) | |
|
|
|
|
6.Disconnect the
7.Disconnect the infrared (IR) blaster connector cable from the connector (CIR Emitter) on the system board.
8.Release the
9.Follow the instructions from step 5 to step 7 in Removing the
10.Follow the instructions from step 5 to step 7 in Removing the Infrared (IR) Blaster Connector.
Replacing the System-Board Shield
1.Follow the instructions in Before You Begin.
2.Follow the instructions from step 2 to step 5 in Replacing the Infrared (IR) Blaster Connector.
3.Follow the instructions from step 2 to step 3 in Replacing the
