speed 100
duplex full
no shutdown

Set Auto-Negotiation Options

The negotiation auto command provides a mode option for configuring an individual port to forced
master/ forced slave after you enable auto-negotiation.
CAUTION: Ensure that only one end of the node is configured as forced-master and the other is
configured as forced-slave. If both are configured the same (that is, both as forced-master or
both as forced-slave), the show interface command flaps between an auto-neg-error and
forced-master/slave states.
Example of the negotiation auto Command
Dell(conf)# int tengig 0/0
Dell(conf-if)#neg auto
Dell(conf-if-autoneg)# ?
end Exit from configuration mode
exit Exit from autoneg configuration mode
mode Specify autoneg mode
no Negate a command or set its defaults
show Show autoneg configuration information
Dell(conf-if-autoneg)#mode ?
forced-master Force port to master mode
forced-slave Force port to slave mode
Dell(conf-if-autoneg)#

Adjusting the Keepalive Timer

To change the time interval between keepalive messages on the interfaces, use the keepalive
command. The interface sends keepalive messages to itself to test network connectivity on the interface.
To change the default time interval between keepalive messages, use the following command.
• Change the default interval between keepalive messages.
INTERFACE mode
keepalive [seconds]
• View the new setting.
INTERFACE mode
show config
View Advanced Interface Information
The following options have been implemented for the show [ip | running-config] interfaces
commands.
When you use the configured keyword, only interfaces that have non-default configurations display.
Example of show Commands that Use the configured Keyword
Example of the show interfaces switchport Command
The following example lists the possible show commands that have the configured keyword available:
430 Interfaces