Configure the following parameters:
–prefix-list-name: the name of an established Prefix list to determine which incoming routes
are modified
–offset: the range is from 0 to 16.
–interface: the type, slot, and number of an interface.
To view the configuration changes, use the show config command in ROUTER RIP mode.

Debugging RIP

The debug ip rip command enables RIP debugging.
When you enable debugging, you can view information on RIP protocol changes or RIP routes.
To enable RIP debugging, use the following command.
•debug ip rip [interface | database | events | trigger]
EXEC privilege mode
Enable debugging of RIP.
Example of the debug ip rip Command
The following example shows the confirmation when you enable the debug function.
Dell#debug ip rip
RIP protocol debug is ON
Dell#
To disable RIP, use the no debug ip rip command.
RIP Configuration Example
The examples in this section show the command sequence to configure RIPv2 on the two routers shown
in the following illustration — Core 2 and Core 3.
The host prompts used in the following example reflect those names. The examples are divided into the
following groups of command sequences:
•RIP Configuration on Core2
•Core 2 RIP Output
•RIP Configuration on Core3
•Core 3 RIP Output
•RIP Configuration Summary
Routing Information Protocol (RIP) 759