hTrigger Out 1 | |
kTrigger Out 1 |
Select the conditions to turn on the trigger out 1 with respect to the zone, input source, surround mode, HDMI monitor, etc.
For details about the trigger out function, see mpage 22.
jTrigger Out 2 | |
lTrigger Out 2 |
This sets the conditions to turn on the trigger out 2, in the same way as “Trigger Out 1” above.
kTrigger Out 3 | |
A0Trigger Out 3 |
This sets the conditions to turn on the trigger out 3, in the same way as “Trigger Out 1” above.
lTrigger Out 4 | |
A1Trigger Out 4 |
This sets the conditions to turn on the trigger out 4, in the same way as “Trigger Out 1” above.
[Selectable items] | ON |
| – – – |
|
|
|
|
Setting with Respect to the Zone
When the power of the zone turned on/off, the trigger out turns on.
Setting with Respect to the Input Source
When the input source set to on is selected, the trigger out turns on.
Associated with respect to the input source for zones set to “ON” at “Setting with Respect to the Zone”.
Setting with Respect to the Surround Mode
When the surround mode set to on is selected, the trigger out turns on.
This is effective when the “MAIN ZONE” has been set to “ON” for the “Setting with Respect to the Zone” and the input source which is set to “ON” has been selected for the “Setting with Respect to the Input Source”.
Setting with Respect to the Monitor
When the HDMI monitor set to on is selected, the trigger out turns on.
This is effective when the “MAIN ZONE” has been set to “ON” for the “Setting with Respect to the Zone” and the input source which is set to “ON” has been selected for the “Setting with Respect to the Input Source”.
| A0Transducer Setup | |
| A2Transducer Setup |
|
| Settings when using transducer. |
|
|
|
|
The Transducer Setup can be accessed through GUI menu “Speaker Setup” – “Subwoofer Setup” is “1SP”, “2SP L/R” or “2SP MIX”. The transducer signal is outputted from “SW3”.
Level [Variable range]
When you adjust “Level”, the adjusted value is set for all surround modes.To adjust the level for individual surround modes, use “Channel
Level” (vmpage 65 |
LPF
Set the upper limit of the low frequency output to the transducer.
[Selectable items]
40Hz |
| 60Hz |
| 80Hz |
| 90Hz |
| 100Hz |
| 110Hz |
| 120Hz |
|
|
|
|
|
|
|
|
|
|
|
|
|
150Hz |
| 200Hz |
| 250Hz |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Getting Started Connections Setup Other Operations
32
