Before starting Auto Setup, Set up the subwoofer

Before starting Auto Setup

If using a subwoofer capable of the following adjustments, set up the subwoofer as shown below.

Set the direct mode to “On” and disable the volume adjustment and crossover frequency setting.

Make the following settings:

•Volume : “12 o’clock position”

•Crossover frequency : “Maximum/Highest Frequency”

•Low pass filter : “Off”

•Standby mode : “Off”

Mount the setup microphone on a tripod or stand and place it in the main listening position.

When placing the setup microphone, adjust the height of the sound receptor to the level of the listener’s ear.

When starting Auto Setup, always use the supplied setup microphone (DM-A409).

Correct measurements cannot be taken if the setup microphone from the prior upgrade (DM-A505Z) is used.

Sound receptor

If you do not have a tripod or stand, set up the microphone on, for example, a seat without a back.

NOTE

•Do not hold the setup microphone in your hand during measurements.

•Avoid placing the setup microphone close to a seat back or wall as sound reflections may give inaccurate results.

3 Connect the setup microphone Connect the setup microphone to the SETUP MIC jack of this unit.

When placing the setup microphone, adjust the height of the sound receptor to the level of the listener’s ear.

When the setup microphone is connected, the setup screen is displayed.

AUTO SETUP

STEP1 Preparation	1 2 3 4 5 6
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
if necessary.
Amp Assign
Channel Select
Auto Setup Start
Enter	RETURN Cancel
Start Auto Setup

AUTO SETUP

STEP1 Preparation	1 2 3 4 5 6
Connect the speakers and place them according
to the recommendations in the manual.
Set the following items
if necessary.
Pre-out Assign
XLR Out Polarity
Channel Select
Auto Setup Start
Enter	RETURN Cancel
Start Auto Setup

Getting Started Connections Setup Other Operations Multi-Zone Information Troubleshooting Specifications