uio ENTER RETURN
STEP5 Check | STEP6 Store | |
|
|
|
In STEP 5, the results of the analysis from STEP 4 are confirmed. | In STEP 6, the measured results from STEP 2 and STEP 3 are saved. | |
Use ui to select the item you want to check, and |
| Select “Store” and then press ENTER. |
1 then press ENTER. |
| Save the measurement results. |
AUTO SETUP | AUTO SETUP |
STEP5 Check | 1 2 3 4 5 6 | STEP6 Store | 1 2 3 4 5 6 |
Check processing results. |
| Press "Store" to store calculation results. |
|
To proceed, press "Next". |
|
|
|
Spkr Config Chck |
|
|
|
|
|
Distance Check |
|
|
|
|
|
Ch. Level Check |
|
| Store |
|
|
Crossover Check |
|
|
|
| |
Next→Store |
|
|
|
|
|
Enter | RETURN | Cancel | Enter | RETURN | Cancel |
Proceed to STEP 6 (Store) |
|
| Apply and store measurement result |
|
|
Getting Started Connections Setup Other
b A value that is different to the measured distance may be set.
b To check other items, press RETURN and select the item that you want to check.
2Use i to select “Next 
Store” and then press
ENTER.
Proceed to “STEP6 Store” (vpage 19).
⇩
AUTO SETUP |
STEP6 Store | 1 2 3 4 5 6 |
Now storing…Please wait. |
|
20% |
Operations
ENTER |
| |
uio | ENTER | |
RETURN | ||
uio | ||
| ||
| RETURN |
(Main remote control unit) | (Sub remote control unit) |
NOTE
•If the result differs from the actual connection status, or if “Caution!” is displayed, see “Error messages” (vpage 21). Check the related items, and implement the necessary measures. After resolving the error, perform Auto Setup again.
•If the result still differs from the actual connection status after remeasurement or the error message still appears, it is possible that the speakers are not connected properly. Turn this unit off, check the speaker connections and repeat the measurement process from the beginning.
•If you change speaker positions or orientation, perform Auto Setup again to find the optimal equalizer settings.
b It takes approximately 20 seconds to finish saving the results.
b If the measuring results are not to be saved, press RETURN. A message “Cancel auto setup?” will be displayed. Press o then select “Yes”. All the measured Auto Setup data will be erased.
NOTE
During saving of measurement results, be sure not to turn off the power.
Information Troubleshooting Specifications
19
