STEP2 Detection & Measurement (main)
i | ENTER |
•In STEP 2, the subwoofer volume level and main listening position volume are measured.
•This step automatically checks the speaker configuration and speaker size, and calculates the channel level, distance, and crossover frequency. It also corrects distortion in the listening area.
•Install the supplied setup microphone to the main listening position.
1Measuring the subwoofer volume level
Select “Measure” and then press ENTER.
Measure the subwoofer volume level.
b When “Channel Select” – “Subwoofer” in the GUI menu is set to “Skip”, the subwoofer volume level is not measured.
b When 2 or 3 subwoofers are used, measure the volume level of each.
bAfter measuring the volume level of the subwoofer, if the following error message is displayed, adjust the subwoofer volume level using “Adjusting the subwoofer volume level” (vpage 17).
AUTO SETUP |
Caution! | 1 2 3 4 5 6 |
The subwoofer's level is too high or low. Please select "SW Level Matching" and adjust the level of your subwoofer unit. If you do not want to use the
subwoofer, select "Skip".
ENTER |
|
i | ENTER |
| i |
(Main remote control unit) | (Sub remote control unit) |
SW Level Matching
Skip
Enter | RETURN Cancel |
Proceed to subwoofer volume adjustment item
2Perform measurement of the
main listening position
When the subwoofer volume level measurement is completely, the connected speakers are detected automatically.
b The measuring channel changes depending on the setting of “STEP1 Preparation” (vpage 14).
b It takes a few minutes for speaker measurement to complete.
b The illustration below shows an example of when the front speakers, center speaker, subwoofer, surround speakers, surround back speakers and front height speakers have been detected.
AUTO SETUP |
STEP2 Speaker Detection Check | 1 2 3 4 5 6 | |||||||
Front | Yes |
|
|
|
| |||
Center | Yes |
|
|
|
| |||
Subwoofer | 1 spkr |
|
|
|
|
|
|
|
Surround | Yes |
|
|
|
|
|
|
|
Surr. Back | 2 spkrs |
|
|
|
|
|
|
|
Front Height | Yes |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Retry
Next→Measurement
Enter | RETURN Cancel |
Proceed to STEP 3 after checking speaker connection result
b If a connected speaker is not displayed, the speaker may not be connected correctly. Check the speaker connection.
b To
4Use i to select “Next 
Measurement” and thenpress ENTER.
Proceed to “STEP3 Measurement (2nd – 8th)” (vpage 18).
NOTE
If “Caution！” is displayed on the television screen, see “Error messages” (vpage 21). Check the related items, and implement the necessary measures. After resolving the error, perform Auto Setup again.
nWhen measuring has stopped
Press ENTER.
Getting Started Connections Setup Other Operations
16
