Setting items

Setting details

 

General

Setup Lock

Default settings are underlined.

Add New Feature Display new features that can be downloaded to this unit and perform an upgrade.

NOTE

In cases where it is not possible to connect to the network after adding a new function, connect to the network again using “Network” (vpage 126).

Upgrade Package : Display the items to be upgraded.

Upgrade Status : Display a list of the additional functions provided by the upgrade.

Upgrade start : Execute the upgrade process.

When the upgrade starts, the power indicator becomes red and the menu screen is shut down. During the upgrade, the amount of upgrade time which has elapsed is displayed.

When upgrading is complete, the power indicator becomes green and normal status is resumed.

If the upgrade is not successful, an error message identical to those in “Update” will appear on the display. Check the settings and network environment and then perform the upgrade again.

See the DENON website for details about upgrades.

When the procedure is complete, “Registered” is displayed in this menu and upgrades can be carried out. If the procedure has not been carried out, “Not Registered” is displayed.

The ID number shown on this screen is needed when carrying out the procedure.

The ID number can also be displayed by pressing and holding the main unit’s TUNER PRESET CH – and STATUS for at least 3 seconds.

Protect settings from inadvertent change.

 

 

Setting items

Setting details

 

 

Lock

On : Turn protection on.

Off : Turn protection off.

When canceling the setting, set “Lock” to “Off”.

NOTE

When “Lock” is set to “On”, the settings listed below can no longer be changed. Also, “Setup Locked!” is displayed if you attempt to operate related settings.

• Setup menu operations

Notes concerning use of “Update” and “Add New Feature”

In order to use these functions, you must have the correct system requirements and settings for a broadband Internet connection (vpage 24).

Do not turn off the power until updating or upgrading is completed.

Even with a broadband connection to the Internet, approximately 1 hour is required for the updating/ upgrading procedure to be completed.

Once updating/upgrade starts, normal operations on this unit cannot be performed until updating/ upgrading is completed. Furthermore, there may be cases where backup data is reset for the parameters, etc., set on this unit.

If the update or upgrade fails, press and hold the X on the main unit for more than 5 seconds, or remove and re-insert the power cord. “Update retry” appears on the display and update restarts from the point at which update failed. If the error continues despite this, check the network environment.

Information regarding the “Update” function and “Add New Feature” will be announced on the DENON web site each time related plans are defined.

When usable new firmware is released with “Update” or “Add New Feature”, a notification message is displayed on the menu screen. When you do not want to be notified, set “Notifications” – “Update” (vpage 134) and “Notifications” – “Upgrade” (vpage 134) to “Off”.

version Basic

version Advanced

Informations

DVD

135