5 Use o p to select the configuration of the connected speakers, and then press
ENTER.
Surround Back Setting for
ZONE2 Setting to assign the unit’s
Front B Setting to use the second set of front speakers for playback.
Front Height Setting for
Front Wide Setting for
6 Press o or BACK to exit the “Amp Assign” setting.
7 | Set up “Channel Select” |
Use ui to select “Channel Select”, and then press
ENTER.
Audyssey Setup
Your AV receiver can automatically measure the acoustics of your room then optimize your speakers using the included microphone.
Set the following items if necessary.
Amp Assign
Channel Select
Start
Channel Select
SubwooferMeasure
8 Use ui to select a channel, and then press ENTER.
Front Select for setting the front speakers to be used. In this case, go to step 9.
•“Front” can be set when “Assign Mode” is set to “Front B”.
Subwoofer Select for no subwoofers to be used. In this case, go to step 10.
Surround Select the number of surround back speakers to be
Back used. In this case, go to step 11.
•“Surround Back” can be set when “Assign Mode” is set to “Surround Back”.
Set up speakers
9 Use o p to select a front speaker, and then press
ENTER.
ASelect this to use front speaker A.
BSelect this to use front speaker B.
A+B Select this to use front speakers A and B simultaneously.
10Use opto set whether or not a subwoofer channel is measured, and then press ENTER.
Measure Set for measuring a subwoofer.
Skip Set for no measuring of a subwoofer.
11Use o p to set whether or not a surround back channel is measured, and then press ENTER.
Measure | Set for measuring two surround back speakers. |
(2spkrs) | |
|
|
Measure | Set for measuring a surround back speaker. |
(1spkr) |
|
|
|
Skip | Set for no measuring of a surround back speaker. |
12Press o or BACK.
Proceed to page 28 Preparation step 5.
NOTE
After performing Audyssey® Setup, do not change the speaker connections or subwoofer volume. In event of a change, perform Audyssey® Setup again.
version Basic
version Advanced
Informations
DVD | 90 |