Denon AVR-5308CI manual 26

Getting	Multi Zone
	ZONE2 or ZONE3 Pre-out Connections
Started
	• If another power amplifier or pre-main (integrated) amplifier is connected, the ZONE2 or ZONE3 pre-out
Connections	(variable or fixed level) connectors can be used to play a different program source in ZONE2 or ZONE3
	to the S-Video or the video connectors. When using a video cable, connect the cable to the video
	the same time (vpage 85 ~ 90).
	• When using a component video cable to connect the AVR-5308CI and input device, connect the ZONE2
	monitor output to the component video connectors. When using an S-Video cable, connect the cable
Setup	connectors.
	• The ZONE2 (ZONE3) video out is only for ZONE2 (ZONE3).
Playback	ZONE2					ZONE3
	Power		Monitor			Monitor	Power
	amplifier						amplifier
ControlRemote	"6%*0			7*%&0		7*%&0	"6%*0
	L	R		4 7*%&0	$0.10/&/5 7*%&0		L	R
	"6%*0		7*%&0			7*%&0	"6%*0
	*/		*/	*/	*/	*/	*/
	-	3			: 1# 13		-	3
-Multi
Zone	L	R					L	R
Information
Troubleshooting

"69	Input
065		Output
Infrared		Infrared	Extension jack for future use.
		sensor
retransmitter

NOTE

•For the audio output, use high quality pin-plug cords so that no induction humming or noise is produced.

•For instructions on installing and operating separately sold devices, refer to the respective devices’ operating instructions.

•To conduct multi-zone playback, see “Amp Assign / Multi-Zone Connections and Operations” (vpage 85 ~ 90).

ZONE2 or ZONE4 Optical Connections

The AVR-5308CI is equipped with Optical output connectors for ZONE2 and ZONE4. If a bit-stream amp is rigged-up, these zones can also be used to enjoy home theater.

AV amplifier		AV amplifier
(ZONE2)		(ZONE4)
	"6%*0			"6%*0
	015*$"-		015*$"-
	*/		*/

•Connect the monitor for ZONE2 the same as the “ZONE2 or ZONE3 Pre-out Connectors”. (vSee left column).

•If the signal inputted to ZONE2 is analog, change to PCM(2-channel) signal, and output it from ZONE2 optical output connectors.

23