•With some remote control units, the signals cannot be learned or the device will not operate properly even when the signals have been learned. In this case, use the device’s own remote control unit.
•Learned buttons have priority over the preset memory. If you no longer need the learned setting, reset the learning function (vpage 81).
NOTE
•[HOME] cannot be learned.
•Do not learn any remote control signals at [RC SETUP].
•The AMP, ZONE2, ZONE3, ZONE4 and SYSTEM CALL modes cannot be learned.
System Call Function
This function lets you register a series of operations at a single button.
For example, the amplifier can be turned on, the input source selected, the monitor’s power turned on, the source device’s power turned on and the play mode set all by pressing a single
button.
Up to 32 signals each can be registered at [SYSTEM CALL] (1, 2 or 3).
Registering
1Press [MODE SELECTOR] for the device you want to register.
2Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice.
3Press [9], [7] and [8], in that order.
The signal transmission indicator flashes twice and the system call registration mode is set.
4Press [SYSTEM CALL] (1, 2 or 3) at which you want to register the signals.
5Press the buttons you want to register in the same sequence as the operations you want to perform.
The signal transmission indicator lights when a button is pressed.
Example : Press [POWER ON].
↓
Press [MODE SELECTOR] – [DVD].
↓
Press [1].
b The mode can be switched by pressing [MODE SELECTOR].
b Perform the registration procedure for all the buttons you want to register.
6Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed.
Calling out
1Press [AMP], to select “SYSTEM CALL”.
2Press [SYSTEM CALL] (1, 2 or 3) at which the signals were registered.
The registered signals are transmitted in the registered sequence.
PunchThrough Function
CD, DVD or VCR mode buttons can be stored at unused TV or SAT/CBL mode buttons.
For example, when DVD mode buttons are assigned to the TV mode, the DVD mode operations can be performed while in the TV mode.
1Press [MODE SELECTOR] for the device you want to punch through (CD, DVD or VCR).
2Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice.
3Press [9], [8] and [4], in that order.
The signal transmission indicator flashes twice and the punch through setting mode is set.
4Press [MODE SELECTOR] for the device you want to punch through (CD, DVD or VCR).
5Press the button you want to punch through (1, 2, 6, 7, 8, 9 or 3).
6Press [MODE SELECTOR] for the equipment (TV or SAT/CBL) you want to set to
7Press and hold in [RC SETUP] for at least 3 seconds. The signal transmission indicator flashes twice and the setting is completed.
Troubleshooting Information
80