Control Remote Playback Setup Connections Started Getting
<STANDARD> <HOME THX CINEMA>
<POWER>
About the button names in these explanations
<> : Buttons on the main unit
[ ] : Buttons on the remote control unit
Button name only:
Buttons on the main unit and remote control unit
Personal Memory Plus Function
This function sets the settings (input mode, surround mode, HDMI output mode, Picture Adjust, Audio Delay etc.) last selected for the individual input sources.
When you switch to an input source, the settings are automatically set to the ones that were set the last time that input source was used.
The surround parameters, tone control, room EQ settings and the volumes of the different speakers are stored for the individual surround modes.
Last Function Memory
This stores the settings as they were directly before the standby mode was set.
When the power is turned back on, the settings are restored to as they were directly before the standby mode was set.
Resetting the Microprocessor
Perform this procedure if the display is abnormal or if operations cannot be performed.
All settings are reset when the microcomputer is reset. However, the information in the Rhapsody account is not reset.
1Turn off the power using <POWER>.
2Press <POWER> while simultaneously pressing
<STANDARD> and <HOME THX CINEMA>.
3Once the display starts flashing at intervals of about 1 second, release the two buttons.
If in step 3 the display does not flash at intervals of about 1 second, start over from step 1.
Troubleshooting Information
Backup Memory
The various settings are backed up for about 1 week, even if the power is turned off or the power cord is disconnected.
75