Troubleshooting Information Zone-Multi Control Remote Playback Setup Connections Started Getting

gManual EQ

Adjust tonal quality for each speaker using graphic equalizer.

Adjust CH

Select speaker adjustment method.

[Selectable items]

Each

 

L/R

 

All

Select the speaker and frequency band and adjust the level.

[Selectable items]

63Hz 125Hz 250Hz 500Hz 1kHz 2kHz 4kHz 8kHz 16kHz

[Variable range]

–20dB ~ 0dB ~ +6dB

Curve Copy

Copy the Room EQ’s “Audyssey Flat” correction curve.

[Selectable items]

Yes

 

No

 

 

 

 

“Curve Copy” is displayed after the auto setup procedure has been performed.

Default

Resets the settings to the default values.

Network Setup

Make network settings.

FMenu tree F

Manual Setup

Network Setup

aNetwork Setup s Other

d Network Information

•If you are using a broadband router (DHCP function), there is no need to make the settings at “Setting the IP Address” and “Setting the Proxy”, since the DHCP function is set to “ON” in the AVR-5308CI’s default settings.

•If the AVR-5308CI is being used connected to a network without the DHCP function, the network settings must be made. In this case, some knowledge of networks is required. For details, consult a network administrator.

•If you cannot connect to the Internet, recheck the connections and settings (vpage 22).

•If you do not understand about Internet connection, contact your ISP (Internet Service Provider) or the store from which you purchased your computer.

•DHCP (Dynamic Host Configuration Protocol) :

These are systems by which the IP address and other network settings are automatically set for the AVR-5308CI, computer, broadband router and network devices.

•DNS (Domain Name System) :

This is a system for converting the domain names used when browsing Internet sites (for example, “www.denon.jp”) into the IP addresses actually used for communications (for example, “202.221.192.106”).

aNetwork Setup

Make settings for wired or wireless LAN.

Wired LAN settings

Use this procedure to configure the Wired LAN settings.

1Connect the LAN cable (vpage 22).

2Turn on the AVR-5308CI (vpage 56).

AVR-5308CI performs automatic network setup due to the DHCP function.

When connecting to a network that has no DHCP function, perform the setting in step 3.

3Set the IP address at the GUI menu “Manual Setup” “Network Setup” – “Network Setup”.

qSelect “Detail”.

e Input the address.

wSet “OFF”.

r Select “Exit”.

qSelect “Detail” and press ENTER.

wUse o p to set “DHCP” to “OFF”, then press i. The DHCP function is disabled.