DFI 915g-tmgf, system board, 915gv-tml user manual Hardware Installation Floppy Disk Drive Connector

2

Hardware Installation

2.6.3 Floppy Disk Drive Connector

3 4	3 3
X

2 1

The system board is equipped with a shrouded floppy disk drive connector that supports two standard floppy disk drives. To prevent improper floppy cable installation, the shrouded floppy disk header has a keying mechanism. The 34-pin connector on the floppy cable can be placed into the header only if pin 1 of the connector is aligned with pin 1 of the header.

Connecting the Floppy Disk Drive Cable

Install one end of the floppy disk drive cable into the shrouded floppy disk header (J11) on the system board and the other end- most connector to the drive you want to designate as Drive A. If you are connecting another drive (Drive B), install the middle connector of the cable to the drive. The colored edge of the daisy chained ribbon cable should be aligned with pin 1 of J11.

BIOS Setting

Enable or disable this function in the Integrated Peripherals submenu (“Super I/O Device” field) of the BIOS. Refer to chapter 3 for more information.

46