Diamondback 600 Tm manual Segment Max HR

600tmOM 8/24/06 11:17 AM Page 41

Workout Programs (continued)

Accepting Default values or Entering the program setting mode

When the dot matrix display shows HR Hill program profile, it indicates you are about to select the HR Hill program:

•Press “START” key to accept current default values and begin HR Hill program workout.

o Default Time = 30 minutes

o Default profile = % max HR profile o Default target HR:

Segment	1	2	3	4	5	6	7	8	9	10	11	12	13	14	15	16	17	18	19	20
% Max HR	65	65	65	70	70	75	75	75	75	82	82	82	75	75	75	75	70	70	65	65

•Or press “ENTER” to enter program setup mode The dot matrix & data displays will take you through the program setup mode step by step as below:

o Enter Age

o Enter Weight o Enter Time

(Note: you may press START key anytime to skip the setup and begin the workout immediately.)

During the Program

Data Display

•When Warm Up mode is completed, this program will begin; the data display window will display the default workout data of “time, calories &

heart rate”. Press “Select” button to switch the data displays.

•Time display will show the selected program time and count down.

•Incline display will start with incline of 0%.

•Heart Rate display:

o If there is no pulse input, the Heart rate data display will show “ - - -“ and blink. If there continues to be no pulse input, this console will maintain its current resistance setting and not changing until the program ends or is changed.

o If there is a valid pulse, the Heart rate display will show the actual pulse reading.

Adjustment

•Computer will adjust the speed to achieve your Heart rate goal; therefore speed can not be adjusted during program run mode. Press Speed ”UP/DOWN” key will adjust the current & future target HR goal proportionally. The dot matrix pro file will update the profile accordingly.

•The numeric quick key can not be used to adjust the target HR setting during program run mode.

•Press Incline “UP/DOWN” key to adjust the incline from 0 -12%. The incline display will update the current & future incline and the dot matrix window will update the incline profile if this display is selected.

•Press “SELECT” key next to dot matrix window to switch the profile display.

Ending the Program

•When selected program time is up, this program will end and Cool down will be active. See Cool down section for details.

600 Tm Owner’s Manual 39