18
USING WHEN A VCR IS INSTALLED
Ifyou installed a VCR using the instructions in Setting Up
to Pass SatelliteProgramming Through Your VCR to
YourTV on page 12, but you would like to use to
switch your TV to the preferred off-air channel, make sure
your VCR is turnedoff before pressing .
16.If the information in step2 on page 13 is a “3,”
write the numbersyou c ircledin Table 2 into the
blankinstep21.
17.If the information in step2 on page 13 is a “4,”
write the numbersyou c ircledin Table 2 into the
blank instep 21, except replace the “3” with a “4.”
18.Press and hold untilboth lightsturn
on (it takes aboutfive seconds).
19.Release . light will flash.
20.Press the RECALL button.
21.Press .
22.Press the MUTE button while watching
light.
23.If the light flashes threetimes, go to step 24.
If light does not flash at all,go back to step 18.
24.Press . Youshould see both your TV and your
VCR change to the channel you wrote in step21
above so that you can watch satelliteprogramming.
25.Press the MENU button. If you seethe satellite
receiver Menu screen, go to step 26. If not, go to
step 15 onpage 16.
26.Youare finished programming the remote control.
SAT TV
SAT
SAT
SAT
SAT