3.3 GENERAL PROGRAMMING
Proceed with the programming steps on the following pages only if PC programming will not be used.
3.3.1 Relay Strike Time
These steps will program Relay 0, Relay 1 and Relay 2 strike times. Strike times can be programmed from 1/4 second (enter 00 in step 4) up to 99 seconds by entering the desired time in seconds. If Tracker expansion boards are going to be used with this system, set Relay 2 strike time to 00 for Tracker boards
Factory setting for relay strike times are: Relay 0 = 99, Relay 1 = 01, Relay 2 = 01.
1.Press *03 and enter the
2.Press 0* to set relay 0, or 1* to set relay 1, or 2* to set relay 2 strike time.
3.Enter the
4.Repeat steps 2 and 3 to set other relay strike times.
5.Press 0# TOGETHER to end this programming step (beeeeeep).
3.3.2 Talk Time
This programming sequence sets the maximum time allowed for conversation when the entry system places a call to the resident. The talk time can be set from 1 second up to 255 seconds (4 minutes, 15 seconds) and is entered as a
Factory setting for talk time = 60 seconds.
1.Press *08 and enter the four digit MASTER CODE _ _ _ _ (beep).
2.Enter three digits for talk time (seconds) _ _ _
3.Press 0# TOGETHER to end this programming step (beeeeeep).
34
