3.2.3 Programming for Call-up Operation
This feature is only used when the telephone entry system is interfaced with a DoorKing 1816 Telephone Intercom system under certain special applications. The factory setting for this feature is OFF. Do not change this feature to ON. Refer to the 1816 Installation Manual, and check with your DoorKing representative on the special applications that this feature is used for.
Factory Setting = OFF
1.Press *78 and enter the
2.Enter 0* (beep) to turn the call up feature OFF. Enter 1* (beep) to turn call up ON.
3.Press 0# TOGETHER to end this programming step (beeeeeep).
3.2.4 PC Programming Table
The information in the chart will be required when you program the PC programmable telephone entry system from your PC. The chart is provided for you to record the information that has been programmed in the preceding steps.
Control Board | Master Code | Memory Size | Memory Chip | Single / Multiple |
Series | (enter number) | (circle one) | (circle one) | (circle one) |
|
|
|
|
|
40E |
| 25 75 125 250 | MemPLUS | SINGLE |
(enhanced) |
| 500 1000 2000 |
|
|
|
| 3000 | STANDARD | MULTIPLE |
|
|
|
|
|
STOP!!
If the telephone entry system is to be programmed from a PC, no other programming is required at the system itself. Complete the chart in section 3.2.4 as this information will be required when programming the unit from your computer. Refer to the Remote Account Manager for Windows software manual for additional programming information. Continue with the remaining sections in this chapter if the telephone entry system will be programmed by any other method. If the factory setting matches your need, there is no reason to reprogram that section.
Remember that relay hold open time zones, security levels, and elevator control functions can only be programmed from the Remote Account Manager software. If any of these features are being used, do not proceed with any other programming steps in this manual.
33