DKS Enterprises 1817 Programming Area Codes, Programming Phone Numbers with Area Code Reference

3.5.3 Programming Area Codes

Up to 10 different area codes can be programmed for any 10-digit or long distance calling requirements and will be referenced 0 through 9 (for a total of 10). The area codes will be entered as a four-digit number (1 + the three digit area code). If area codes are being programmed to facilitate 10-digit calling requirements, precede the three-digit area code with #.

1.Press *24 and enter the four-digit MASTER CODE _ _ _ _ (beep).

2.Enter the area code reference number (0 through 9) _ then press * (beep).

3.Enter the area code _ _ _ _ then press * (beep). NOTE-1: for long distance calling

requirements, enter 1 and the three-digit area code. NOTE-2: for 10-digit calling requirements, enter # and the three-digit area code.

4.Repeat steps 2 and 3 to enter additional area codes. Remember to use a different area code reference number when entering more area codes.

5.Press 0# TOGETHER to end this programming step (beeeeeep).

3.5.4 Programming Phone Numbers with Area Code Reference

In this section, phone numbers that are referenced to an area code (long distance and 10-digit dialing calls) will be programmed. Be sure that the area code(s) have been programmed as described in the preceding section.

NOTE: If long distance or 10-digit dialing is not required, program the seven digit telephone numbers as described in 3.5.2.

1.Press *41 and enter the four-digit MASTER CODE _ _ _ _ (beep). The display will show CO.

2.Enter the directory code (1, 2, 3 or 4 digits depending on what was programmed in 3.5.1) then press * (beep). The display will show PHONE#.

3.Enter the area code reference number _ then press * (beep).

4.Enter the seven-digit phone number _ _ _ _ _ _ _ then press * (beep). If the number that you are entering in this step is less than seven-digits, enter # in the empty spaces. See 3.5.2, step 3.

5.Repeat steps 2, 3, and 4 to enter additional long distance phone numbers.

6.Press 0# TOGETHER to end this programming step (beeeeeep).

44