6.1.2 Weigand Test (1815, 1817 Systems Only)
This programming sequence will allow you to view the weigand data on the display as it is received by the control board. This will allow you to verify that the weigand device is functioning properly.
1.Press *82 and enter the
2.Enter 9 9 9 9 * (beep).
3.Activate one of the weigand input devices by placing a card on a card reader, pressing a transmitter button, or entering a digital code on a weigand keypad.
4.If the weigand data is shown on the display, this verifies that the weigand device is operating properly and sending the information to the entry system. If no data appears on the display, the weigand devices are not functioning.
5.Press 0# TOGETHER to cancel the weigand test mode.
6.1.3 Elevator Board(s) Hardware Test
This programming sequence is designed for trouble shooting the elevator control board(s) that may be connected to the telephone entry system. This sequence will take approximately four (4) minutes to complete and will check the operation of the CALL relay, and then all the odd numbered relays, then all the even numbered relays on the elevator control board(s). This test confirms communication between the telephone entry system circuit board and the elevator control board(s).
1.Press *76 and enter the
2.The display will show: WHICH ELEVATOR? (1815 - 1817 systems only).
3.Enter the elevator shaft number (1, 2, 3 or 4) _ then press * (beep).
The display will show: ELEVATOR TEST 1 (1815 - 1817 systems only).
Once the test starts, the CALL relay (LED ON) will activate, and then ALL odd numbered relays will activate, and then ALL even numbered relays will activate on the 1st elevator control board. After this sequence, if more than one elevator control board is connected, ALL odd numbered relays, and then ALL even numbered relays will activate on the 2nd elevator control board. After this sequence, ALL odd numbered relays, and then ALL even numbered relays will activate on the 3rd elevator control board. After this sequence, ALL odd numbered relays, and then ALL even numbered relays will activate on the 4th elevator control board. This sequence will repeat itself ten (10) times.
4.Once the test is complete (approximately 4 minutes), this programming sequence will automatically end itself.
62
