Dynacord DMM 4650 owner manual List of factory preset sequences

List of factory preset sequences

Sequence Nummer

S 20

Step Command Parameter

1:Break

2:End

Title	Priority	Stopp trigger
“stop all”	99	off

Stops all running sequences

Description: Stops all running sequences with low priorities (all factory presets). Upon completion the DMM 4650 returns to the stand-by mode.

Sequence Nummer	Title	Priority	Stopp trigger
S 21	“Alarmtxt”	97	off

Step	Command	Parameter
1:	Out	A1 set
2:	wt	In A1 High
3:	Out	B4 clr
4:	Out	B2 set
5:	Out	B3 set
6:	Out	A2 set
7:	Sum=	off
8:	DMM=	-2dB
9:	Start	M 00
10:	wt	Audio

11:End

Start alarm text (message 00) once

Description: Turns the sound reinforcement system on (relay A1) and waits for acknowledgment (input A1 = system ready). When the system is ready, the output B4 (music program off) is opened and B2, B3 (mandatory reception E, D) is closed. After closing the signaling contact (A2 = alarm text running) the audio controls are set to alarm text priority. The alarm text (M00) is given out. After the transmission of the message is completed, the se- quence is finished and the device returns to the stand-by mode, i. e. all line and relay contact settings re-enter the status, prior to the start of the sequence.

Sequence Nummer	Title	Priority	Stopp trigger
S 22	“DIN-Alrm”	93	off

Step	Command	Parameter
1:	Out	A1 set
2:	wt	In A1 High
3:	Out	B4 clr
4:	Out	B2 set
5:	Out	B3 set
6:	Out	A3 set
7:	Sum=	off
8:	DMM=	-5dB
9:	Start	A 20
10:	wt	Audio

11:End

Start continuous DIN alarm (siren 1200 Hz - 500 Hz, per second)

Description: Turns the sound reinforcement system on (relay A1) and waits for acknowledgment (input A1 = system ready). When the system is ready, the output B4 (music program off) is opened and B2, B3 (mandatory reception E, D) is closed. After closing the signaling contact (A3 = alarm signal running) the audio controls are set to alarm text priority. The alarm signal (A20) is outputted and runs continuously until it is stopped by a sequence with a higher priority (e.g. S20). The control of the settings and relay contacts is taken over by the stop sequence and upon completion the DMM 4650 returns to stand-by mode.

37