Dynacord DMM 4650 owner manual Priority Stopp trigger Ansage D3 Low 00,1s stc, BZB ABC alarm

Sequence Nummer	Title	Priority	Stopp trigger
S 32	“Ansage”	80	D3 Low >00,1s stc

Step	Command	Parameter	Announcement via recording input DMM 4650 as long as the
1:	Out	D3 set	key is being pressed (System input -20 dB).
2:	Sum=	-20dB	Description: Closing the signaling contact (D3 = announcement
3:	DMM=	-3dB	running) switches the audio controls of the sum input to -20 dB
4:	Start	Ann.	and the controls of the announcement to -3dB. After the correct
5:	wt	Stop	level was set once in the operation menu (announcement), the
6:	End		announcement is made via one of the DMM 4650’s recording
			inputs. When the message has ended the DMM 4650 returns to
			the stand-by mode.

Sequence Nummer	Title	Priority	Stopp trigger
S 33	“BZB-ABC”	95	off

Step	Command	Parameter
1:	Out	A1 set
2:	wt	In A1 High
3:	Out	B4 clr
4:	Out	B2 set
5:	Out	B3 set
6:	Out	A3 set
7:	Sum=	off
8:	DMM=	-5dB
9:	Count=	0003
10:	Start	A 27
11:	wt	Audio
12:	Dly=	012,0s
13:	wt	Delay
14:	if	Count
15:	Jump	17
16:	Jump	10
17:	Dly=	006,0s
18:	wt	Delay
19:	Count=	0003
20:	Dly=	012.0s
21:	wt	Delay
22:	Start	A 27
23:	wt	Audio
24:	if	Count

25:End

26:Jump 20

27:End

BZB ABC alarm

Description: Turns the sound reinforcement system’s power on (relay A1) and waits for acknowledgment (input A1 = system ready). When the system is ready, the output B4 (music program off) is opened and B2, B3 (mandatory reception E, D) is closed. Closing the signaling contact (A3 = alarm signal running) swit- ches the audio controls to the alarm signal’s priority. The signal sequence is defined as follows: 1 minute siren interrupted by two breaks (=5 * l2sec, siren = 330 - 420 Hz), break 30 seconds and repeating of the signal sequence (total duration 150 sec.); the utilized alarm preset is A 27 = 12 sec. siren. Afterwards the DMM 4650 returns to the stand-by mode.

42