Dynacord DMM 4650 owner manual Sequence Nummer

Sequence Nummer			Title	Priority	Stopp trigger
	S 25		“Vierklng”	89	off
Step	Commend	Parameter	4-tone gong
1:	Out	A1 set	Description: Turns the sound reinforcement system on (relay A1)
2:	wt	In A1 High
			and waits for acknowledgment (input A1 = system ready). When
3:	Out	B4 clr	the system is ready, the output B4 (music program off) is being
4:	Out	B2 set	opened and B2, B3 (mandatory reception E, D) gets closed. After
5:	Out	B3 set	closing the signaling contact (A4 = gong runs) the audio controls
6:	Out	A4 set	are set to gong priority. The gong signal is being output and
7:	Sum=	off	fades. After the fade-out the DMM 4650 returns to stand-by
8:	DMM=	-5dB	mode.
9:	Start	G 20
10:	wt	Audio

11:End

Sequence Nummer	Title	Priority	Stopp trigger
S 26	“Vorgong”	87	B4 Low >00,1s stc

Step	Command	Parameter	Start Pre-gong (key B4 on), end of announcement with key
			B4 off
1:	Out	B4 clr
2:	Out	B2 set	Description: The output B4 (music program off) is opened and in
3:	Out	B1 set	succession B2 (mandatory reception E) is being closed. After
4:	Sum=	-3dB	closing the signaling contact (B1 = pre-gong runs) the audio
5:	DMM=	-5dB	controls are set to audio input/pre-gong mix. After 4 seconds the
6:	Start	G 24	signaling contact (B1, ready for announcement) is being opened.
7:	Dly=	004,0 s	The audio controls remain unchanged until control input B4
8:	wt	Delay	terminates the sequence. Afterwards, the DMM 4650 re-enters
			the stand-by mode.
9:	Out	B1 clr
10:	wt	Audio
11:	wt	Stop

12:End

Sequence Nummer

S 27

Stepp	Command	Parameter
1:	Out	C1 set
2:	Sum=	off
3:	DMM=	-2dB
4:	Start	M 01
5:	wt	Audio

6:End

Title	Priority	Stopp trigger
“Message1”	80	off

Start Message 1

Description: After closing the signaling contact (C1 = message runs) the audio controls are set to prioritize this message. After the message is finished the DMM 4650 re-enters the stand-by mode.

39